Installation Sheet

Assembly Instructions: 3167-FM15 (Colson)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, please
contact the place of purchase.
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the
important notes above. Remove the old xture from
the ceiling, including the old mounting strap.
1.Ifyouarehangingthisxturewiththeshade,please
attachshade(I)toframe(L)byliningupholes(K)ofthe
shadewithholes(M)ontheframe.Securetheshadeto
theframewithscrews(J).
2.Takethemountingstrapassemblyfromtheparts
bag.Oneendofnipple(F)shouldbeattachedto
mountingstrap(A)withwasher(C)andhexnut(D)in
place.
3.Placemountingstrap(A)overthejunctionboxand
securemountingstrap(A)tothejunctionboxwith
mountingscrews(B)andascrewdriver.Tightenthe
screwssecurely.
CONNECTING THE WIRES
4.Haveanassistantsupportthexture’sweight
whilecompletingthewiring.Refertothewiring
diagrambelowandattachthexture’swires
tothepowersupplywiresfromthejunction
box.ConnectHottoHot,NeutraltoNeutral,
andGroundtoGround.Twisttheendsofthe
wirepairstogether,andthentwistonawire
connector.Makesurealltwistsareinthesame
direction.Ifthereisnohousegroundwire
comingfromthejunctionbox,locateground
screw(E)onthemountingbracket/mounting
strapandwrapthexture’sgroundwirearound
thegroundscrew.Useascrewdrivertotighten
thetopofgroundscrew(E)ontothewiresand
intothemountingbracket/mountingstrap.Tuck
thewiresintothejunctionbox.
FINISHING THE INSTALLATION
5.Raiseceilingpan(N)totheceiling.Positionnipple(F)sothatitprotrudesthroughtheopeninginceilingpan(F).Secureceilingpan(N)
inplacewithdecorativenut(H).
6.Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommendedwattage.
Yourinstallationiscomplete.Turnonthepowerandtestthexture.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
GND
JUNCTION
BOX
A
B
C
E
D
M
N
H
I
J
K
G
F
L