Instructions / Assembly

Assembly Instructions: 1323-1W (Ella)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromthewall,includingthe
oldmountingstrap.
Mountingstrap(B)containsseveralpairsofthreadedholes.
Findthepairofholesthatmatchesthespacingoftheholeson
thejunctionboxandyourxture’sbackplate.Note:Inorderfor
thexturetohangstraight,brackets(C)shouldbecenteredat
thetopandbottom.Pullthehousewiresthroughthecenterof
mountingstrap(B).Placemountingstrap(B)overthejunction
boxsothatmountingscrews(A)arehorizontal,andinalignment
withtheholelocationsonthexture’sbackplate(F).Secure
mountingstrap(B)tothejunctionboxwithmountingscrews(A)
andascrewdriver.Tightenthescrewssecurely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblack(hot)tosmooth/black/transparent
(L);white(neutral)toribbed/white/transparent(N);andground
(green)tobarecopper/green/transparentwithgreeninterior.
Twisttheendsofthewirepairstogether,andthentwistona
wire connector. Make sure all twists are in the same direction.
Ifthereisnogroundwire(greenorcopper)fromthejunction
box,locategroundscrew(E)onthemountingbracket/mounting
strapandwrapthexture’sgroundwirearoundthegreen
groundscrew(E).Useascrewdrivertosecuregroundscrew(E)
ontothemountingbracket/mountingstrap.Tuckallwiresneatly
intothejunctionbox.
FINISHING THE INSTALLATION
Placebackplate(F)overbrackets(C)ofmountingstrap(B)and
line up the holes on the top and bottom of the backplate with
the holes in brackets (C). Insert screws (D) into the holes at the
topandbottomofbackplate(F)anduseascrewdrivertotighten
the screws securely.
Slide candle sleeve (J) over socket (I).
Installlightbulb(K)(notprovided)inaccordancewiththe
xture’sspecications.
Your installation is now complete. Turn on the power and test
thexture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down
the xture with a clean lint-free cotton or microber cloth. Dry with a lint-free or microber cloth.
For Customer Service, contact
the place of purchase.
E
A
B
D
C
F
G
H
I
J
K
Smooth / Black /
Transparent (L)
Black (Hot)
Ribbed / White /
Transparent (N)
Bare Copper / Transparent with
Green Interior / Green
White (Neutral)
Green
(Ground)