Owner Manual

11
Assembly Instructions
A. Choose a good location to install the sauna
1. The location must be dry, leveled, and away from any source of water.
2. The stove must be installed by a certified electrician.
3. Two adults are required for installation on model GDI-7289-01 and three adults
for installation on models GDI-7389-01/GDI-7689-01.
4. Wood cabin installation order: REAR WALL PANEL RIGHT SIDE WALL
PANEL LEFT SIDE WALL PANEL FLOOR PANEL FRONT WALL
PANEL SECOND LAYER BENCH SUPPORT PANEL FIRST LAYER
BENCH SUPPORT PANEL SECOND LAYER BENCH FIRST LAYER
BENCH BACKREST ON REAR WALL PANEL BACKREST ON RIGHT
SIDE WALL PANEL FAN SHAPED BENCH RIGHT SIDE BENCH
SUPPORT PANEL RIGHT SIDE BENCH REINFORCEMENT RIGHT
SIDE BENCH ROOF PANEL
5. Tools Required: Battery Operated Screwdriver or Hand-Held Philips Screwdriver,
Rubber Mallet, Claw Hammer, Leveler, and Ladder.
B. Installing the REAR WALL PANEL and RIGHT SIDE WALL PANEL
1. Place the REAR WALL PANEL upright. Next, stand the RIGHT SIDE WALL
PANEL upright and up against the REAR WALL PANEL. Locate the screw holes
on the exterior side and screw the two wall panels together using the provided
screws. (see Figure 4 & 5)
Figure 4