Instruction Manual

Operating your Heater
To start using the heater switch on the master switch at the back of the heater.
HEAT SETTINGS
To change the heat setting touch the icon. Underneath the thermostat temperature on the
main display screen, dots will appear to signal what heat setting you are in. The light on the top of
the unit will also change colour depending on what heat setting you are in as per the below:
1 Dot Blue Fan Only Mode
2 Dots Green Heat Setting 1
3 Dots Red Heat Setting 2
The light can be turned off using the icon on the remote.
OSCILLATION / SWING
To make the heater oscillate, touch the icon and the heater will begin an oscillation cycle.
The angle of oscillation is approximately 75°.
ELECTRONIC THERMOSTAT
The temperature around the heater will always be displayed on the front screen. To increase the
temperature touch the icon and to decrease the temperature touch the icon. When the
room temperature reaches the preset temperature, the heating function will stop automatically.
When the room temperature is lower than preset temperature, the low or high heating will turn on
automatically. The thermostat range is between 16° and 37°.
TIMER
Hold on the icon for 5 seconds to change the display to the timer mode. Press the icon
to increase the timers hours and touch the icon to decrease the timers hours. The timer will
flash 3 times before confirming your set countdown time. The timer range is between 1 to 9 hours.
NOTES
• The heater’s fan will continue to run approximately 30 seconds after the heater is turned off.
This is so the fan can cool down the ceramic heating element.
• The display screen will automatically dim approximately 100 seconds after the icons have
been touched.