Operating Instructions Oil Column Heater Model: GOC215, GOC217, GOC2111
This page is intentionally left blank.
General Care and Safety Guide YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
General Care and Safety Guide • Never use the appliance to dry clothes. • Always unplug appliance when not in use. • When the appliance has been unpacked, check it for transport damage and ensure all parts have been delivered. If parts are missing or the appliance has been damaged, contact the Customer Services Team. • Do not use if there are visible signs of damage to the appliance. • Do not connect the appliance to mains supply until completely assembled and adjusted.
General Care and Safety Guide • The appliance must not be immersed in any liquids. • There are no user serviceable parts installed in the unit. • Do not place the unit in wardrobes or other enclosed spaces as this may cause fire hazards. • This unit is not supposed to be used in or around locations where foodstuffs, works of art or delicate articles of science, etc. are stored. • If your appliance does not work, or is not working properly, contact the place of purchase or the Customer Services Team.
Components Of Your Oil Column Heater A. B. C. D. E. F.
Assembly ASSEMBLY OF THE HEATER 1. Remove the dome nut from the castors, fit castor thread through the castor mounting plate. Replace dome nut and tighten. 2. Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not fall. Be careful to prevent damage to the cosmetic finish or your floor surfacing. 3. Unscrew the wing nuts from the U-shaped bolt provided, fit the U-shaped bolt over the connector between control panel and second fin. 4.
Operating Your Heater Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions. WARNING: In order to avoid overheating or fire, do not cover the heater. WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
Operating Your Oil Column Heater Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. This appliance requires no installation, it should be used solely as a portable appliance. HEAT CONTROL BUTTONS The heating element heating options are: | Low heat || Medium heat | + || High heat For greater economy, use the high heat setting initially and then switch to the lower heat settings. THERMOSTATIC CONTROL 1.
Operating Your Heater SAFETY DEVICES This appliance has three protection devices: • Tilt Switch - this will automatically turn the appliance off if the appliance is not in the correct operating position. • Resettable Thermal Link - this will automatically disconnect the power to the appliance at a pre-set overheat temperature. After cooling down it will reset and power on again. If this occurs, investigate what is causing the appliance to overheat.
Two Year Warranty Thank you for purchasing this Goldair product. Your product is warranted against faults and manufacture when used in normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three months. Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.
New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.
