Instruction Manual

Speed
Press speed to change fan speed from 'high-mid-low', the relevant speed indicator LED will light
up.
Timer
If you wish to turn the appliance off at a pre-determined time press the timer button. The
appliance can be set to turn off at any time between 0.5 hours and 7.5 hours.
To set the timer, turn the appliance on at the desired speed, press the timer button until the
desired run time is illuminated. The fan will turn off once the time has expired. If no time is
selected, the appliance will operate continuously.
Cool Mode
To initiate the cooling function press the ‘cooler’ button. This function blows normal air through
a water curtain to cool the air. Press the button again to switch this function off and the
appliance will operate in fan only mode.
Note: You must have water in the water tank for this function to work. It will take a few minutes
for the cooler air to come out of the appliance.
Wind
Press the ‘Wind’ button to choose either Normal, Natural or Sleep setting.
Normal - A continuous wind blow that can be adjusted to low, med and high speed.
Natural - Natural setting provides a soft and comfortable environment with a selection of low,
medium and high speeds.
Sleep - WHEN HIGH fan speed is selected, the fan will run at HIGH for 30 minutes, then it will
reduce to MEDIUM fan speed for 30 minutes, then it will change to LOW speed and then
continue to operate in the LOW speed until turned off.
- When MEDIUM fan speed is selected, the fan will run at MEDIUM for 30 minutes, then it will
reduce to LOW speed and then continue to operate in the LOW speed until turned off.
- When LOW fan speed is selected, the fan will continue to operate in the LOW speed until
turned off.
Swing
Pressing the swing button will make the air guide rotate to better distribute air.
To stop the rotation, press the swing button again.
Remote control
The remote requires a line-of-sight path to allow for the signal to be received by
the unit. Position the unit so the receiver lens is visible from the remote control.
The symbols on the Remote correspond to the symbols on the main unit.
Remote control battery The remote control comes with a CR2025 lithium coin
cell battery. To install, remove the battery cover on the bottom of the remote
control. Remove any plastic protection from the battery and place it in the
Remote with the + side facing out. Then reposition the cover onto the bottom
of the remote.
If your remote no longer works, please try replacing with a new CR2025 battery.
CAUTION do not leave the appliance operating unattended.
IMPORTANT! NEVER COVER THIS APPLIANCE!
Operating your Fan