Instruction Manual

Care and cleaning
When not in use disconnect the appliance from the power outlet and drain all water
from the water reservoir.
To ensure effective humidifying and filtering, it is recommended that the filtering
system be cleaned once every 1-2 weeks.
Before cleaning the appliance, disconnect the appliance from the mains supply.
Empty the water reservoir by loosening the plug of the water drainage outlet. Make
sure you have a container under the drain to collect the water or empty the appliance
outside. You may have to empty the water collector a few times, finally replace the
plug of the water drainage outlet.
The air filter is connected into the back cover via two clips at the top. To clean the air
filter release by pressing the two clips down and give it a little push. Be careful not to
damage the filter.
Note: Never use appliance without the air filter.
CAUTION: do not immerse or allow the motor or electric cables to come in
contact with any liquid.
To clean the exterior surfaces simply wipe over with a soft damp cloth.
Should it be necessary, greasy marks may be removed from the surfaces by using
mild soap and a cloth dampened in hot water. Avoid all other types of detergents,
cleaners, or solvents that may contain chemicals which could damage parts of the
appliance. Thoroughly dry all parts before storage.
Store in a Cool dust free location for next use.
Do not use this appliance with a programmer, timer, separate remote-control system
or any other device that switches the appliance on automatically.
Do not attempt to dismantle the appliance. There are no user serviceable parts. For
service or repair, contact an authorised electrical service technician.
Goldair New Zealand
Monday Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz
Goldair Australia
Monday Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
info@cdbgoldair.com.au
SUPPORT AND TECHNICAL ADVICE
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
Cleaning and Maintenance