Instruction Manual

On/Off
Turn the appliance ON by pressing the
ON/OFF button. The appliance will start
in the default mode of normal/low speed
setting.
Speed
Press speed to change fan speed from
“high-mid-low”, the relevant speed
indicator LED will light up.
Timer
If you wish to turn the appliance off at a
pre-determined time press the timer
button. The appliance can be set to turn
off at any time between 0.5 hours and
7.5 hours.
To set the timer, turn the appliance on at
the desired speed, press the timer button
until the desired run time is illuminated.
The fan will turn off once the time has
expired. If no time is selected, the
appliance will operate continuously.
Cool Mode
To initiate the cooling function press the
cool button. This function blows normal
air through a water curtain to cool the
air. Press the button again to switch this
function off and the appliance will
operate in fan only mode.
Note: It will take a few minutes for the
cooler air to come out of the appliance.
Note: You must have water in the water
tank for this function to work.
Swing
The horizontal louver can be shifted
manually for the air outlet to blow up or
down to suit.
The vertical louvres can be set to your
desired direction or allowed to oscillate
by pressing the swing button.
Operating your Fan
Modes
There are 3 Mode functions:
Normal, Natural or Sleep.
• Normal Mode: Constant air flow
which can be adjust by pressing the
speed function button. For example,
normal LOW or normal MEDIUM or
normal HIGH.
• Natural Mode: Programmed to
simulated natural air flow (wind) as if
it was entering via the window.
Natural mode can be operated in
high, medium or low speed.
• Sleep Mode: Programmed to provide
comfort while the user is asleep. This
mode is similar to the natural mode
and can operate with speed mode
HIGH or MEDIUM or LOW.
Remote control
The remote requires a line-of-sight path
to allow for the signal to be received by
the appliance. Position the appliance so
the receiver lens is visible from the
remote control.
The symbols on the remote correspond
to the symbols on the main appliance.
Remove battery cover and install two
“AAA” batteries (not included).
CAUTION do not leave the appliance
operating unattended.
IMPORTANT! NEVER COVER THIS
APPLIANCE!