User's Manual

Activity Counter Installation and Service
User Guide
August 22, 2013 7
Adhesive mount
An adhesive pad is included for situations where screws are not desired or practical.
 Peel the release liner off one side of the adhesive pad and apply it to the base plate of the
Universal Mount
 Position the remaining base plate on the ceiling or wall.
 Peel the remaining release liner off the adhesive pad and firmly press the pad and base
plate against the surface of the ceiling or wall
Assemble and Adjust the Universal Mount
 Place the cover over the wall plate
 Orient the extension as desired, and then fully seat the extension against the wall plate
(capturing the cover). The extension may be omitted depending on the desired angle and
placement of the activity counter.
 Secure the extension by tightening the included set screw using a 1/8” or 3mm hex wrench.
 Orient the pivot arm as desired, and then fully seat it on the extension (or the wall plate if
the extension was omitted).
 Secure the pivot arm by tightening the included set screw using a 1/8” or 3mm hex wrench.
 Adjust the angle of the pivot arm as desired by loosening the included screw and nut. When
the screw is retightened, the arm will not move.
 Orient the previously assembled Activity Counter mounting plate and Universal Mount base
plate with the arrow pointing toward the door or entry.
 Secure by tightening the included set screw using a 1/8” or 3mm hex wrench.
 Once the mounting plate has been secured, position the Activity Counter over the tabs on
the plate and twist clockwise to finish the installation. It is advised to steady the mounting
plate with one hand while twisting the Activity Counter. Note that the mounting plate is
keyed so that the Activity Counter will only fit in one orientation.
Wall mounted
Base Plate
Extension
Cover
Pivot Arm