User's Manual

Activity Counter Installation and Service
User Guide
August 22, 2013 12
Data Refresh Rates
The data in the column labeled Updated is populated each time a sensor is activated (dispenser
actuations or activity sensor movement detected). This data is also updated every 30 seconds by default
or by clicking on the refresh icon on the top right corner of the sensor area (see below):
Associating Sensors to Areas
An important part of setting up your system for accurate tracking involves mapping, or associating,
sensors to specific areas (floors, units and rooms) of the hospital. This association is the foundation for
compliance reporting across the hierarchy of the system.
Instructions for mapping your sensors
1) Open the Sensor Map screen in the tabular view mode.
2) Expand the hierarchy tree for the floor, unit and rooms which you will associate the Activity
Counter.
3) Click and hold a the ID from the sensor table and drag it to the room it will be associated with;
releasing the mouse button after you see the green plus sign on the hierarchy item (room).
4) After successfully associating the sensor to the room, the sensor table will update accordingly
To remove a sensor from the hierarchy, click on the sensor in hierarchy tree and press your Delete key
on the keyboard. This removes any association between that sensor and a room or hierarchy level. It
will need to be remapped after removing it.
A sensor can be moved from one hierarchy level to another. This is convenient when you need to
change the room a sensor is mapped to, for example.
Removing and Changing Sensor Locations
To remove a sensor from the hierarchy tree, simply locate it by expanding the associated room, click on
the sensor to highlight it, and then press your delete key. This only removes the association between
that sensor and the room it was linked to.
Clearing Sensor Data
During installation and testing each sensor will be activated several times to determine accuracy and
validated data transfer. After the system is formally tested and validated, the GOJO system
administrator may clear the counts to allow for a fresh start of data collection. The small broom icon in