User's Manual

8.3.3 Brake lever setting
● Rotate the barrel adjuster on the lever to properly set the cable tension. When you
pull the brake levers, they should be about 1 ½ inches (3.8 cm) away from the grip on
the handlebars. If the levers hit the handlebars when you pull them, the brake cables
are too loose.
8.3.4 Torque values for threaded fasteners
○ Handle bar: T45 Torx - 15 Nm.
○ Seatpost clamp: 4mm hex - 10 Nm.
○ Screw underneath the saddle: 4mm hex - 10 Nm.
○ Front wheel axle (both sides): 6mm hex - 1.8 Nm.
○ Rear wheel axle (both sides): 19mm open-end - 29.4 Nm.
○ Crankset: Use 8 mm hex - 48 Nm.
○ Front brake pads: 4mm hex - NA.
○ Rear brake pads: 5mm hex - 5.9 Nm.
9. Troubleshooting
Situations
Possible reasons
Solutions
I can’t install the pedal
on the crank.
You might have mixed
the right and left pedal.
Check The right and left mark on pedals,
The left pedal has left-handed thread.
Turn counter-clockwise to tighten the left pedal.
The right pedal has right-handed thread.
Turn clockwise to tighten the right pedal.
The saddle is too high
for me, even if I have
dropped the seatpost to
the end.
The seatpost is too long.
We provide several different lengths of
seatposts to choose from where you purchase
your Smartwheel™.Please choose a proper
length to fit your needs.
Please consult your local dealer or contact us
via the Gogoro Smartwheel APP or website if
necessary.
The saddle is too low
for me, even if I have
pulled the seatpost out
and reached the safety
line.
The seatpost is too
short.
I can’t I pair my
smartphone with
Gogoro B01?
The pairing is
incompleted
Please make sure that:
1. Smartphone’s bluetooth is on
2. Smartphone is connected to the
network
3. You have scanned the QR code for the
Smartwheel™ that you are trying to pair
with.
4. Plug and unplug charger on Gogoro
B01 to reboot system.
21