User's Manual

● Adjust saddle placement to fit your body geometry.
○ Use 5 mm hex wrench to loosen the screws underneath the saddle rails.
○ Adjust position and angle of the saddle, then tighten the screws.
○ Torque: 5 mm - 9.2 Nm.
8.3.2 Transmission belt tension adjustment
● Proper tension is essential for optimum operation of Gates Carbon Drive System.
○ Use 5 mm hex wrench to loosen screws of dropouts (2 screws each side,
both sides).
○ Use 10 mm open-ended wrench to loosen flanged nuts of dropouts (1 flanged
nuts each side, both sides).
○ Use 2.5 mm hex wrench to loosen/tighten the bolts of dropouts synchronously
(1 bolt each side, both sides), and adjust the belt tension to 45-60Hz ( 35-45
lbs) via GATES CARBON DRIVE MOBILE APPS in a quiet environment.
○ Torque: 2.5mm - NA / 5mm - 19.6 Nm / 10mm - 6 Nm

Note: The tension recommendations are a good starting point, which may need to
be adjusted higher or lower based on the rider size, gear ratio, and power placed
on the pedals.
20