User's Manual
Warning: When the battery is left to be at a low level of charge for too long, it can
become damaged. Please connect the charger and keep the battery fully charged
when you are not using the Gogoro B01.
Warning: In order to protect the battery from damage by over-discharge, be sure
to charge the battery to full level before you store of ship the Gogoro B01, and
charge the battery at least once per month.
Warning: Always connect the charger both to the wall AC outlet and B01. NEVER
leave B01 on the charging stand without connecting to wall AC outlet for more
than 1 month, to prevent battery damage.
Warning: Do not use any kind of wax or polishing agent on matte or non-glossy
surface, no matter what material it is, and do not wipe or rub strongly, to avoid
damaging the exterior surface.
Warning: Do not use any detergent or wax on brake and belt transmission system,
to avoid damaging and cause danger. No lubrication is needed on this product.
8.3 Advanced adjustment
The following procedures require advanced tools and technical knowledge. If you don’t know
how to proceed and have no specificed tools, please consult professional bicycle technician,
or contact us via the Gogoro Smartwheel APP or website.
8.3.1 Saddle height / placement adjustment
● Adjust saddle height to fit your body geometry.
○ Pry off the rubber cover.
○ Use 2 mm hex wrench to remove the protection cover.
○ Use 4 mm hex wrench to loosen the seatpost clamp screw, adjust the saddle
height and tighten it.
○ Do not pull the seatpost beyond the “Minimum” insertion limit mark.
○ Tighten all the screws.
○ Torque: 2 mm - NA / 5 mm - 9.2 Nm.
19