User Manual

EN - 20
EN
Point the remote control at the remote control sensor on the front panel. The remote control works with in a
distance of about 8 meters from the sensor and within an angle of about 30 degrees from the left and right side.
NOTE:
Remove the batteries when you don‘t intend to use the remote control for a long time.
Do not mix new and used batteries, or di󰀨erent types of batteries.
Weak batteries can leak and severely damage the remote control.
Be environmentally friendly and dispose of batteries according to your government regulations.
USAGE CONNECTION
Subwoofer connection
Make sure the AC power cord for the subwoofer is connected to a power supply securely. Power on the
soundbar, press and hold
button for 5 seconds, the subwoofer can receive the wireless audio signal
from the soundbar. When the red indicator ashes on the subwoofer, the subwoofer is in searching wireless
signal status, the blue indicator keeps lighting on the subwoofer means the soundbar and subwoofer were
connected.
Press and hold [ PAIR ] button on the Subwoofer or press and hold
button for 5 seconds to disconnect
with the soundbar and the red indicator on the subwoofer ashing when the subwoofer and soundbar was
disconnected, press [PAIR] button on the Subwoofer or press and hold
button on the soundbar for 5
seconds again, the subwoofer will be reconnected with the soundbar.
OPTICAL digital audio input > OPt
Connect the Digital Optical Audio cable (not included) to the optical output on the audio source and to the
Optical Input on the soundbar. Press the
button on the remote control to switch to Optical mode or press
the
button on the main unit repeatedly to select the Optical mode.
Using the remote control on your connected device, make sure the audio settings are set to PCM or optical
Audio and are turned On. Audio from the connected audio source will now be played through the speakers.
HDMI ARC (CEC) > ArC
Connect the ARC Audio cable (not included) to the ARC output on the audio source and to the ARC Input on
the soundbar. Press the
button on the remote control to switch to ARC mode or press the button on
the main unit repeatedly to select the ARC mode.
Using the remote control on your connected device, make sure the audio settings are set to ARC or HDMI
Audio and are turned on. Audio from the connected audio source will now be played through the speakers.
HDMI CEC - This function allows to control the CEC-enabled devices, that are connected through HDMI
ports by using the remote control of the TV.
Bluetooth connection > bt
Press STANDBY button on the remote control to power on the soundbar, then press
button on the
remote control to switch the bluetooth mode, the word no bt will be shown on the display screen, the
soundbar is in searching bluetooth signal status. Use your smart phone to search the bluetooth signal
of the soundbar, select GOG TAS950WSB on your list. Input the password 0000 if need the password
prompt, the sound bar will synchronize to play songs on your mobile phone while the word bt is shown
on the display screen and a beep will be heard means to be connected successfully. Disconnected the
bluetooth on the smart phone to switched o󰀨 the bluetooth connection.
NOTE: Do not connect the TV to the soundbar via Bluetooth due to sound delays.
USB Mode > Usb
Insert the USB stick with the MP3 music tracks into the socket marked „USB“ on the soundbar. Press the
button until the soundbar switches to the USB mode. The soundbar will start playing the MP3 track
automatically from the connected USB drive. If play does not start automatically, press
button .
LINE IN > LINE
After turning on the soundbar and Press the
button until soundbar switches to the Line in mode. Use
the Line in cable (3,5mm) or RCA cable (3,5mm) to direct connect smart phone, tablets, and other music
devices.