SP-1 Quick Start Manual
S TAT I S TI CS VITAL STATISTICS LENGTH/HEIGHT/WEIGHT: 12.5”/ 7.5”/ 2lb, 5oz OPERATING PRESSURE: Approx 160 to 200 psi max PAINTBALLS: .
S P - 1 WARNI NGS PLEASE READ CAREFULLY – THE SP-1 IS NOT A TOY. – MISUSE OF THE SP-1 MAY RESULT IN SERIOUS INJURY OR DEATH. – EYE PROTECTION SPECIFICALLY DESIGNED FOR PAINTBALL USE MUST BE IN COMPLIANCE WITH ASTM SPECIFICATION F1776 AND MUST BE USED BY THE USER AND ANYONE WITHIN RANGE OF THE SP-1. – WEAR EYE PROTECTON DURING DISASSEMBLY OR MAINTENANCE. – SMART PARTS RECOMMENDS THAT THE SP-1 ONLY BE SOLD TO PERSONS 18 AND OLDER. – THOROUGHLY READ THE SP-1 MANUAL BEFORE OPERATING.
SETUP 01 PLEASE READ CAREFULLY 02 BARREL BLOCKER Screw the included barrel into the SP-1. Slide the included barrel blocker over the barrel and secure its cord as far back on the SP-1 body as possible, cinching it tight. The barrel blocker is a critical piece of paintball safety equipment – nearly as important as paintball goggles.
DI S AS SE MBLY/ C LEA N IN G PLEASE READ CAREFULLY WET WEATHER NOTE: BOLT BOLT STOP BOLT SLEEVE REAR COVER PLAYING IN THE RAIN WILL NOT DAMAGE YOUR SP-1, BUT YOU SHOULD NEVER IMMERSE IT IN WATER. IF YOUR MARKER SHOULD BECOME WATERLOGGED, REMOVE THE BARREL AND RUBBER GRIPS AND ALLOW THEM TO DRY OUT, THEN FOLLOW THE DISASSEMBLY/ CLEANING INSTRUCTIONS. The SP-1 valve system has only one major moving part, making it simple to maintain, but this does not mean maintenance can be ignored.
UN L O ADI NG/DEG A SSIN G Before storage, transport or maintenance, your marker will need to be unloaded and degassed. In an area where it is safe to shoot and while wearing paintball goggles, loosen the SP-1’s clamping feedbeck and remove the loader. By turning the marker upside down, you can empty any extra paintballs from the feedneck into your hand. Remove the CO2 or HPA tank.
WA R R ANTY Smart Parts warrants for one (1) year to initial retail purchaser that the paintball marker and regulator are free from defects in materials and workmanship. Disposable parts (batteries, o-rings, seals, springs, etc.) are not warranted. The valve assembly is warranted for six (6) months. The solenoid and electronics on the marker are warranted for six (6) months, plus an additional warranty of six months for electronic parts only (installation and labor are not included.
00.922.2147 100 Station St. Loyalhanna, PA 15661 www.smartparts.com manual version Web.
