User's Manual

DISASSEMBLY/CLEANING

800.922.2147 www.smartparts.com

PLEASE READ CAREFULLY

The Vibe valve system has only one major moving part, making it simple to maintain, but this does not

mean maintenance can be ignored. The Vibe should be disassembled and cleaned any time it shows erratic

performance, becomes contaminated with paint, dirt or other debris, or for general maintenance after 3 or 4

days of use.

01 Unload and degas the Vibe. Remove the barrel and use a 5/16-inch allen wrench to unscrew and

remove the bolt sleeve from the back of the Vibe.

02 Using a soft tool, like a wooden chopstick or plastic toothbrush, push the bolt and bolt stop out the

back of the Vibe.

03 Clean the interior of the body, the bolt sleeve, bolt and bolt stop with a clean cloth or paper towel.

Inspect their o-rings for signs of damage such as rips or cuts and replace if necessary.

04 Lubricate o-rings with SL33K marker lubricant. Slide the bolt stop onto the bolt from the rear. Slide

the rear of the bolt into the front of the bolt sleeve. Hold this assembly vertically, with the front of

the bolt pointing up, and insert it, upwards into the rear of the Vibe. Screw the bolt sleeve into place

with a 5/16-inch allen wrench – do not overtighten.

This is all that is required for routine maintenance. Further disassembly of the Vibe receiver and grip frame

should be avoided unless necessary for repair, as it may shorten the life of the marker. For additional infor-

mation, please visit the support section at www.SmartParts.com

WET WEATHER NOTE:

PLAYING IN THE RAIN WILL NOT DAMAGE

YOUR VIBE, BUT YOU SHOULD NEVER

IMMERSE IT IN WATER. IF YOUR MARKER

SHOULD BECOME WATERLOGGED,

REMOVE THE BARREL AND RUBBER

GRIPS AND ALLOW THEM TO DRY OUT,

THEN FOLLOW THE DISASSEMBLY/

CLEANING INSTRUCTIONS.

BOLT BOLT STOP BOLT SLEEVE