User Guide
6
Hardware Installation
We recommend CAT5e/6 with 100% copper
wiring and IEEE-T568B wiring standard.
One to One Configuration
1. Power off all devices including your HDMI
source and HDMI display(s).
2. Connect your HDMI source device to the
Transmitter's HDMI Input connector with
an HDMI cable (HDMI cable not included).
3. Optional: Connect an HDMI display to the
Transmitter's HDMI out connector with an
HDMI cable (HDMI cable not included) for
local monitoring of the HDMI signal.
4. Optional: Connect the IR Blaster Extension
Cable to the Transmitter's IR output port.
Face the eye towards your HDMI source
device's IR window. This connection is
needed only if you need to control your
HDMI source from the remote location.
5. Plug your CAT5e/6 cable between the
Transmitter's RJ45 Output and Receiver's
RJ45 Input.