User Guide
4
Installation Requirements
1. HDMI source device (computer, DVD
player, etc.)
2. HDMI display device (SDTV/Monitor,
HDTV/Monitor, projector, etc.)
3. UTP/STP CAT5e/6 cable following
IEEE-568B wiring standard
1. IR Window
Receives IR signals from the included remote
control to set/select the channel
2. Power LED On when transmitter is powered on
3. TX ID Displays transmitter's ID number
4. Reset Button Press the button to reset the transmitter
5. Power Jack Connects to the included power adapter
6. Data LED Blinks when data transmission is detected
7. RJ45 Output
Connects to the receiver's RJ45 Input using a
CAT5e/6 cable
8. Link LED Lights up when RJ45 signal detected
9. IR Output Connects to the IR Blaster extension cable
10. HDMI Out Connects to a local HDMI display
11. HDMI Input Connects to the HDMI source device
12. RS232 RS232 pass through
Product Layout
Figure 1: Transmitter (TX)