User Manual

21 ........................................ ........................................ 22 ........................................ ........................................
(6) Select "T2 fixture" in the "fixture calibration" interface and then click "T2A".
(7) Enter the calibration of the A side of the T2 fixture, replace the T2 fixture and
lock it according to the prompts, rotate the fixture to the A side up, and then
click "Start Calibration"
(8) After completing the calibration, place a blank key on side A and clamp it, and
click "Start Calibration" again
(9) After completing the calibration, click "Exit" to finish the calibration of the T2
fixture A side.
(10) Then complete the calibration of T2b, T2C and T2D in turn, and the installati-
on interface prompts calibration.
(11) After all four sides are calibrated, T2 fixture calibration is completed.
(12) This step is already calibrated at the factory, and it is recommended to recali-
brate after replacing the new fixture (the original fixture is damaged or lost
during the cutting process) (Note: After completed the calibration , the repl-
acement between the T1 and T2 fixtures not need to re-calibrated).
4.4CarDatabase
(1) Firstly determine the model and year of the car when copy key. On the main
interface of the key cutter, click "Car Database" to enter the next page.
(2) Enter the vehicle manufacturer or model in the search box, or select the model
from the list, and click to enter the next page.
GODZILLA Key Cutting Machine-Operation instructionsGODZILLA Key Cutting Machine-Operation instructions