User Manual

17 ........................................ ........................................
(5) Tighten the cutter and probe, and click "Exit" to complete the leveling.
(6) After the machine steady stopped, according to the installed milling cutter
diameter, click "Processing Settings", select the corresponding milling cutter
diameter on the interface depending on the actual needs, and click "Settings"
to complete the setting, and then click "Close" to exit.
18 ........................................ ........................................
4.2Levelingthechangedheight
(1) On the main interface of the software, click "Device Parameters".
(2) On the "Device Parameters" interface，click“Leveling the changed height”.
(3) Follow the instructions on the interface to replace the T1 fixture and lock it.，
and then click "Start" to enter the Leveling process.
(4) After the machine steady stopped, you can adjust the milling cutter and the
probe. When both states show green light, it is leveled.
GODZILLA Key Cutting Machine-Operation instructionsGODZILLA Key Cutting Machine-Operation instructions