User Manual

(4) Follow the interface prompts, replace the T1 fixture and lock it, then click
"Start Inspection" to enter the calibration program.
(5) After the machine steady stopped , click "return" to exit the interface and
complete T1 fixture offset detection.
15 ........................................ ........................................
(6) Select "T2 fixture" in the "fixture offset detection" interface.
(7) According to the interface prompt, replace the T2 fixture, keep the B side
upward, and then click "start detection" to enter the calibration procedure.
(8) After the machine steady stopped , click "return" to exit the interface and
complete T2 fixture offset detection.
(9) This step is already calibrated at the factory, and it is recommended to re-
calibrate after replacing the new fixture (the original fixture is damaged or
lost during the cutting process) (Note: After completed the calibration , the
replacement between the T1 and T2 fixtures not need to re-calibrated).
16 ........................................ ........................................
GODZILLA Key Cutting Machine-Operation instructionsGODZILLA Key Cutting Machine-Operation instructions