User Manual

- 23 -
Test Flash
1. Press the <TEST> Trigger Button to see the
whether flash will fire normally or not.
2. Fully press the <TEST> Trigger Button, and
the Status Indicator Lamp turns red and the
flash on the receive end can be triggered.
3. The settings on the transmitter end will
synchronize to the receiver end at the same
time.
Setting the Transmitter
- 24 -
Sound Control
Short press the < > Button can control the
ON/OFF of sound.
Lock Functions
Long press the < > Button can lock the current
settings and long press the < > again to unlock.
Modeling Flash Control
Short press the < > Button can control the
ON/OFF of modeling lamp.
Power Output Settings
1. Turn the Select Dial to adjust the power output
level.
*As XT32 can control so many flashes and
each flash has different power output level,
there are 6 modes to be displayed. Choose
one according to your needs.
Long press the <SET> Button over 2 seconds
until the power output level is displayed. Turn
the Select Dial to choose the power output
mode.
Display
1/128+0.3(by default)
1/128+0.1
1/256+0.3
1/256+0.1
1.0
5.0
Description
Power output range: 1/128~1/1; Power output adjustment: 1/3
Power output range: 1/128~1/1; Power output adjustment: 1/10
Power output range: 1/256~1/1; Power output adjustment: 1/3
Power output range: 1/256~1/1; Power output adjustment: 1/10
Power output range: 1.0~7.0; Power output adjustment: 0.1
Power output range: 5.0~10; Power output adjustment: 0.1
Setting the Transmitter
2. Quickly double-click the SET button to control
the ON/OFF of the power output.