User Manual

- 21 -
Setting the Transmitter
Slide the Power Switch to ON, and the device is
on and Status Indicator Lamp will not blink. When
in idle use, the flash trigger will enter sleep mode
after a period of time (set as 1 minute/3 minutes/
10 minutes/30 minutes). Press any button or half
press the camera can wake it up.
Setting the sleeping time: Long press the < >
Button over 2 seconds until the settings screen is
displayed on the panel. Turn the Select Dial to
choose the sleeping time.
Note: In order to avoid power consumption, turn
off the transmitter when not in use.
Power Switch
Slide the power switch to ON, and the AF lighting
is allowed to output. When the camera cannot
focus, the AF assist beam will turn on; when the
camera can focus, the AF assist beam will turn off.
Power Switch of AF Assist Beam
Channel Setting
1. Short press the < > Button until the channel
amount blinks.
2. Turn the Select Dial to choose the appropriate
channel. Press the < > Button again to
confirm the setting.
3. This flash trigger contains 32 channels which can
be changed from 1 to 32. Set the transmitter and
the receiver to the same channel before usage.
Setting the Transmitter
Group Settings
1. Short press the < > Button and the selected
group will blink.
2. Turn the Select Dial to choose the appropriate
group. Press the < > Button again to confirm
the setting.
3. This flash trigger contains 16 groups which can
be changed from 0 to 9 and A to F. Set the
transmitter and the receiver to the same group
before usage.
- 22 -