Operation Manual

Setting the Transmitter

Group Settings

Setting the Transmitter

Test Flash

5. The settings on the transmitter end will synchronize to the receiver end at the same

time.

1. Press the <TEST> Trigger Button to see the

whether flash will fire normally or not.

2. Fully press the <TEST> Trigger Button, and

the Status Indicator Lamp turns red and the

flash on the receive end can be triggered.

3. Use the transmitter to control camera to

focus or shoot, and the transmitter is

connecting to the camera (do not connect to

the flash) now.

4. In the standby mode, press the TEST

Button can wake up the receiver.

Setting GR Grouping Mode

Note: GR mode can only be used normally when attaching to the CANON EOS cameras that

issued after 2012. In the GR mode, multi flash cannot be set.

1. Press the <MODE> Mode Button until Gr

icon is displayed, which shows that GR

grouping mode has been set.

2. To cancel GR grouping mode, press the

<MODE> Button again until the Gr icon

disappeared.

- 38 -- 37 -

Modeling Lamp Control

Double-click the <CH/OK> Button to power ON/OFF the modeling lamp.

1. Long press the <GR> Button to set all effective groups simultaneously.

2. The settings of all effective groups will blink. Turn the Select Dial to change the

settings, until one of the group's setting turns to the maximum or the minimum and all

settings of the effective groups will not change now.

3. If the current group is in the M mode, the power output value is changeable from 1/1

full power to Min. power in 0.3 stop increments, until one of the group’s setting turns to

the maximum(1/1) or the minimum(Min.). If the current group is in the TTL mode, all

the other groups which are in the M mode will change their FEC amount

simultaneously. The FEC amount is changeable from -3 to 3 in 0.3 stop increments,

until one of the group’s setting turns to the maximum(3) or the minimum(-3). If the

current group is in the -- mode (flash off), the amounts will not change.

4. If the groups in the M mode or TTL mode work together, the first FEC amount which

up to the maximum or the minimum is considered as the limitation.

5. Short press the <GR> Button again to confirm the setting.