Operation Manual

Setting the Transmitter
1. Press the <CH/OK> Button for 2 seconds or longer until <Fn> is displayed.
2. Select the custom function No.
* Turn the Select Dial to choose the Custom Function No.
3. Change the Setting.
* Press the <GR> Button until the custom function No. blinks.
* Turn the Select Dial to set the desired number. Pressing <GR> button will confirm the
settings.
* Press <MODE> button to exit the C.Fn settings.
Setting the Transmitter
Wireless Shutter Release Mode
Half press the <TEST> Trigger Button to focus. Fully press the <TEST> Trigger Button,
and the Status Indicator Lamp turns red. Now camera is ready to shoot. When releasing
the button, the Status Indicator Lamp turns off.
Setting the Camera
Use the External Flash Function on the camera to do the setting.
Note: 1. GR mode can only be used normally when attaching to the CANON EOS cameras that
issued after 2012. If the camera model do not support GR grouping flash mode,
NON GR mode will be changed automatically.
2. In the NON-GR mode, Ration Off is steadily set in the TTL mode while A:B C is steadily set
in the M mode.
Setting the Receiver
Channel Setting
1. Short press the <CH> Button and the channel
amount will increase a step each time.
2. Long press the <CH> Button will enter quicker
adjustment mode. The channel amount will
increase fast in this mode.
3. Release the <CH> Button and the current
channel amount is confirmed.
[Note 2]:
Second curtain sync cannot be set through the camera's external flash functions setting.
When using second curtain sync, the effective shutter speed range is from 1/30s to 30s. When shutter speed
is set as buLb or is quicker than 1/30s, the settings are invalid.
After being turned on, second curtain sync is effective even though HSS has been set and the shutter speed
range is from 30s to 1/30s.
After second curtain sync is turned on, synchronization delay settings are invalid.
√
√
Double-click the CH Button to turn on/off the modeling lamp of the receive end.
Press the TEST Button to turn on the flash trigger. When the Status Indicator Lamp blinks two
times, it means the effective remote distance is below 30 meters, thus the transmitter and receiver
can communicate normally no matter how near they are.
Settings and Description
Setting Signs
FunctionsCustom
Functions No.
Application
- 41 - - 42 -
After the setting value were changed, it will
send the setting value.
It will send the setting value mandatory before
the trigger flash, although the setting value
have no change.
--
on
Mandatory
send the setting
value
ON/OFF
C.Fn-08
√