Operation Manual

Setting the Transmitter
Automatically Enter Power Saving Mode
1. The flash trigger will go into standby mode after the transmitter enter sleep mode, and
the displays on the LCD panel will disappear.
2. Press any of the button (<TEST> fully pressed/<CH/OK>/<GR>/<MODE>) can wake
up the flash trigger. If the transmitter is attached to the CANON EOS camera, half
press the shutter can also wake up the system.
3. If the transmitter is set to single contact mode( isdisplayed), the system will not
enter power saving mode.
The following table lists the available and unavailable custom functions of this flash. The
icon“√”indicates the flash custom function is supported but “0”indicates the custom
function is not supported.
Settings and Description
No delay
Synchronization delay N*100 us
(synchronization delay icon is displayed.)
OFF
ON(The single contact mode set icon
is displayed.)
Setting Signs
00
1~100
--
on
Functions
Synchronization
delay setting
Single contact
mode
Custom
Functions No.
C.Fn-00
C.Fn-01
Application
√
√
C.Fn: Setting Custom Functions
Setting the Transmitter
Settings and Description
It is advisable to set the transmitter to single
contact mode when using it to trigger the flash
by PC cord or through camera’s single contact.
OFF
Changing with camera's zoom value.
Zoom(20/24/28/35/50/70/80/105/135/
200mm)
PC sync socket connects with camera as an input
PC sync socket connects with flash as an output
Second curtain sync off
Second curtain sync on
1/128
1/256
3 groups are displayed
5 groups are displayed
Turn off the beeper on the receive end
Turn on the beeper on the receive end
Setting Signs
on
--
AU
20,24,28,35,50,70,
80,105,135,200
In
ou
--
on
1/128
1/256
03
05
--
on
Functions
Single contact
mode
Zoom setting
PC sync socket
as an input/
output
Second curtain
sync [Note 2]
Minimum power
output value in
M/Multi mode
Displayed
groups
Beeper ON/OFF
Custom
Functions No.
C.Fn-01
C.Fn-02
C.Fn-03
C.Fn-04
C.Fn-05
C.Fn-06
C.Fn-07
Application
√
√
√
√
√
√
√
- 39 - - 40 -