User Manual

Power Supply
1. Firstly, plug the two ends of
connect cord separately into
the controller’s output control
port and the light’s power input
socket. A “click” will be heard
once finished.
2. Plug the output end of adapter’s connect cord into
controller’s power input end.
3. Use the power cord to connect the power supply.
Operation
1. Power on/off: long press the Power Switch of controller to
power the LED light on or off.
2. Choose group/channel: press GR/CH button for once, and
turn the Select Dial for Light Brightness to change the channel
value. Then, press GR/CH button again, and turn the Select Dial
for Light Brightness to change the group value (the group figure
will be displayed recurrently). Press GR/CH button to exit.
3. Light brightness adjustment: turn the select dial for light
brightness to change the value from 0% to 100%.
4. Power option: press the GR/CH button and power the light
on to enter power option mode. Turn the brightness select dial to
choose power from 300, 250 and 200. The power is 300W by
default. Exit from this mode automatically without operation for 5
seconds.
1. With 433 MHz wireless system, VL series have remote grouping and control function. Up to
6 groups of LED lights can be controlled. 16 channels are available with strong anti-
interference capability. Please set the channels and groups of LED light to the same as those
of RC-A5II remote control before usage.
Adjusting Channel/Group of the Controller
● Press the GR/CH button and the channel icon blinks. Turn the select dial for light brightness
to choose a channel ID (1 to 16).
● Press the GR/CH button twice and the group icon blinks. Turn the select dial for light
brightness or color temperature to choose a group ID (A to F).
Adjusting Channel/Group of the Remote Control
● Press the CH/GRP button and the group icon blinks. Press the “-” or “+” button to choose a
group ID (A to F).
● Press the CH/GRP button twice and the channel icon blinks. Press the “-” or “+” button to
choose a channel ID (1 to 16).
Adjusting Light Brightness with the Remote Control
● Press the “-” or “+” button to adjust the light brightness.
- 11 - - 12 -
Wireless Control (433MHz wireless & smartphone APP through Bluetooth)
Note: The wireless signal can be received only when the controller is power on.
2. Godox VL series LED lights can also be controlled by smartphone APP through Bluetooth
with 6 groups and 16 channel.
● Bluetooth connection: power the LED light on and long press the GR/CH button until a
Bluetooth ID is displayed on the controller. Then, open the “GodoxPhoto”APP, click the
Bluetooth and choose the corresponding Bluetooth ID of the controller. Finally, enter the
password (the initial password is “000000”), and the Bluetooth is successfully connected.
Note: The channels and groups of LED controller and APP should be adjusted to the same.
● LED control: please find more details in
the “GodoxPhoto” APP of smartphone:
Setting---Help---LED.
GR/CH
BRIGHTNESS
GR/CH
BRIGHTNESS
BRIGHTNESS
蓝牙主页
3965
E965
4659
其他设备
清除设备
12: 00
3893
Note: If using V-port battery, please insert the battery into the LED light and power it
on for usage.
Note: This function is used for the situation that the battery enter to protection states and cannot word due
to some v-port battery doesn't output the corresponding power in strong power output. When enter this
mode, the output power of the light can be decreased and the battery can be loaded instead of being
protected (this function only applies to VL300).