Operation Manual

Body

1. Sync Cord

2. Power Cord

3. Instruction Manual

Accessories

1. Power Socket 2. Sync Cord Jack 3. Power Switch 4. Flash Output Controller

5. Optical Control and Anti-Preflash Switch 6. Modeling Lamp Switch 7. Buzz Button

8. Test Button 9. Flash Output Level Indicator 10. Slave Trigger Indicator

11. Modeling Lamp Indicator 12. Buzz Indicator 13. Charging Indicator Lamp

14. Fuse 15. Mounting Bracket 16. Umbrella Input 17. Light Sensor

Flash Preparation

Test Button

Attach the flash unit on an

appropriate light stand.

Adjust the mounting bracket

(15) for a good angle and

make sure it's tightened and

fixed.

The umbrella input (16) is

applicable for any studio

umbrella.

Power Connection

Connect the flash to an AC power source via power cord and turn on the power

switch (3). The charging indicator lamp (13) remains off, indicating the unit is

charging, no flash at this moment. When the unit is ready to fire, the charging

indicator lamp (13) is on.

Flash Output Control

Flash output controller (4) controls the power radio, adjustable power from 1/8

to full.It can meet customers' requirements for light in different environment.

(Note: When adjusting the power from full power to a lower setting, press the

test button to release the power in the capacitor, so when recharged, the flash

output will be in the corresponding setting.)

To fire the flash without taking a picture, push the test button. It will also adjust

the brightness when combined with the flash output controller (4).

Sync Triggering

The sync cord jack (2) is

a Φ3.5mm mini plug.

When working with sync

cord triggering method,

insert one end of sync

cord or a trigger plug

into it; the flash then

can be fired synchronously.

1 2

Names of Parts

Operations