Operation Manual

- Do not touch the two terminals of the tube outlet as there is high voltage inside. Wear

insolated gloves before replacing the tube or modeling lamp.

- Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.

- Do not flash directly towards naked eyes (especially those of babies), otherwise it may

lead to visual impairment.

- Disconnect from the power supply when it will not be used for an extended period.

Body

NAMES OF PARTS

1. AC Power Socket 8. Slave Model Button SLAVE 15. Light Sensor

2. Sync Cord Jack 9. Test Button 16. Fuse

3. Power Switch 10. Digital Display 17. Mounting Bracket

4. Modeling Lamp Output Controller 11. Modeling Lamp Indicator 18. Umbrellas Input

5. Flash Output Controller 1 2 . B u z z I n dicator 19. Direction Adjusting Handle

6. Modeling Lamp Button MODEL 13. Slave Trigger Indicator 20. Wireless Control Port

7. Sound Button 14. Test Indicator Lamp

1. Sync Cord

2. Power Cord

3. Standard Reflector

4. Lamp Cover

5. Glass Protection Cover

6. Modeling Lamp

7. Instruction Manual

Accessories

- 03 -

Separately sold accessories

The product can be used in combination with the following accessories sold separately, so as to

achieve best photography effects:

FT-16 Remote Control, Power Inverter, Softbox, Photographic Umbrella, Light Stand,

Barndoor, Snoot, etc.

OPERATIONS

Flash Preparation

1. Take down the lamp cover.

Install the modeling lamp and put

on the glass protection cover and

the standard reflector.

(To uninstall the standard

reflector, press the orange

release button on the flash head

and turn the standard reflector

counter-clockwise to take it out, as illustrated in the picture.)

2. Attach the flash unit on an appropriate light stand. Adjust the mounting bracket (17) for a

good angle and make sure it’s tightened and fixed. Use the direction adjusting handle (19) to

adjust the flash on a desired direction. Umbrella input (18) is for different photo umbrellas to put

in.

- 04 -