Operation Manual

FOREWORD
Thanks for choosing Quicker high-speed flash. It has wide-range applicability, not only
perfect for all kinds of studio and workshop photography, but also good at wedding,
portrait, advertisement, and fashion photography. Without recycling time limits,
photographers can capture a series of fast-changing facial expressions and amazing
moves, and clearly freeze each fleetingly perfect instant into eternal beauty. Among the
benefits you’ll enjoy:
Ultra-speedy charging, 0.05-1.2s recycling time
Multi-freeze shots, 1/5000s-1/800s flash duration
Up to 10 shots in one second under high-speed continuous shooting
Exact output control on LED display, 50 steps from 5.0-10.0 by 0.1 increment
High qualified modeling lamp, 150W output adjustable
Outstanding output stability, less than 2% shifts when under the same output
High color stability, ranging within ±100k between flashes over the entire power range
Flash output on/off and power level,modeling lamp and buzzer on/off,and flash triggering can be
controlled by using Godox FT series romote control.
CONTENTS
01 Foreword
05 Power Output Control
02 For Your Safety
05 Test Button
02 Caution
05 Sync Triggering
05 Slave Trigger Model
03 Names of Parts
06 Buzz Function
03 Body
06 Memory Function
04 Accessories
06 Wireless Control Function
04 Separately Sold Accessories
06 Tube Replacement
04 Operations
07 Technical Data
04 Flash Preparation
05 Power Connection
07 Maintenance
05 Modeling Lamp
•
•
•
•
•
•
•
•
•
•
•
•
•
•
FOR YOUR SAFETY
To prevent damage to the product or injury to you or to others, read the following safety
precautions in their entirety before using this equipment. Keep these safety instructions
where users can read them for ready reference.
Do not disassemble or modify !
There are high-voltage components inside the unit. Failure to observe this precaution could
result in electric shock or product malfunction. Should the product break open as the result of a
fall or other accident, send the defective back to authorized service center for inspection and
maintenance.
Keep dry !
Do not handle with wet hands or immerse in or expose to water or rain. Failure to observe this
precaution could result in fire or electric shock.
Keep out of the reach of children !
This device contains small parts that may pose a choking hazard. Consult a physician
immediately if a child swallows any part of this device.
Do not expose to high temperature !
Do not leave the device in a closed vehicle under the sun or in other areas subject to extremely
high temperature. Failure to observe this precaution could result in fire or damage to the
housing or internal parts.
CAUTION
- 02 -- 01 -
- After 30 continuous flashes at full power, the flash should be cooled down for about 3
minutes. Overheating will occur if it is used continuously without cooling down.
- Do not keep using the modeling lamp for a long time, otherwise flammable accessories
attaching to flash head, e.g. softbox will get burnt. A 10-minute time is recommended in
this case. After 10 minutes, cool it down for 1 minute.
- When using a snoot, do not keep the modeling lamp on for a long time or fire too
frequently (not over six times for one minute). Overheating will result in damages for
strobe housing and/or studio light.
- Do not touch the lamp cap when the flash or modeling lamp is working, as it will give out
heat, leading to high surface temperature.