User Manual

Shut down the power and remove the power cord before replacing the flash tube
and wear insulated gloves. Then, loosen the iron wire on the tube, keep a
balanced hold on the two feet of the flash tube and pull out the old tube gently.
Take down the feet casing from the old tube and put it on the new one. Hold two
feet of the new tube, and target directly towards the two copper outlets, then push
them slightly in. Twine the iron wire on the stainless steel sheet to fix the flash
tube.
Tube Replacement
For full instructions on the use of FT series remote control, see its user manual.
To control the flash wirelessly, you need a Godox FT series remote control set (on-
camera and on-flash). Insert its receive end into the Wireless Control Port (17) on
the flash and insert the transmit end into the camera hot shoe. Settings made on
the hotshoe-mounted transmit and receive ends will be wirelessly communicated
to the flash. Then you can press the camera shutter-release button to trigger the
flash.
The flash unit is built in with a Wireless Control Port (17) so that you can wirelessly
control the on-and-off of your flash, modeling lamp and buzzer, as well as adjust
the flash output level, etc.
Wireless Control Function
The device is equipped with memory function for the panel setting. It will help
remember the panel setting 3 seconds after you set it. When starting up the flash
next time, the panel setting will be the same as that before powering it off.
Memory Function
TECHNICAL DATA
MAINTENANCE
Avoid sudden impacts and the lamp should be dedusted regularly.
Shut down the device immediately when it works abnormally and find out the reason.
Changes made to the specifications or designs may not be reflected in this manual.
Disconnect the power when cleaning the flash or when changing the flashtube /
modeling lamp.
If the product had failures or was wetted, do not use it until it is repaired by
professionals.
Unauthorized service will void the warranty.
This product, except consumables e.g. flash tube and modeling lamp, is supported
with a one-year warranty.
Maintenance of the flash must be performed by our authorized maintenance
department which can provide original accessories. The flash-tube and the modeling
lamp are user-replaceable. Replacement tubes and lamps can be obtained from the
manufacturer.
It is normal for the lamp to be warm when in use. Avoid continuous flashes if
unnecessary.
- 13 - - 14 -
Dimension
Net Weight
Gs200
200WS
49
Gs300
300WS
58
Gs400
400WS
65
Flash diameterΦ12.5CM, height of flash with handle 25CM,
length of flash with lamp cover 35CM
Approx. 1.8KG Approx. 1.9KG Approx. 2KG
AC110V-120V~60Hz/0.3-1.5s or AC220V-240V~50Hz/0.3-1s
5600±200K
AC110V-120V~60Hz or AC220V-240V~50Hz
OFF, 5.0~8.0 (1/32~1/1)
150W
Sync cord, Test button, Slave triggering, Wireless control port
1/2000~1/800s
5V
5V/200mA (only for Godox receiver)
AC220V-240V~50Hz: 5A / AC110V-120V~60Hz: 8A
Model
Max Power (WS)
Guide Number(m ISO 100)
Color Temperature
Operating Voltage
Power Output Control
Modeling Lamp (W)
Recycle Time
Triggering Method
Flash Duration
Parameters output from
the sync cord jack
Parameters output from
the USB port
Fuse