User Manual

Power Management
1. Power Supply
Two power supply modes is available:
● Using lithium battery: This light uses SONY NP-F970 model lithium battery.
Note: When using lithium battery, press the Battery Indicator Button and the battery
level will be displayed.
2. Installing Lithium Battery
● Turn the Power Switch off.
● Target the socket of the lithium battery
towards the "+" "-" contacts of the Battery
Compartment. Push the battery in until it
locks.
● Power the light on.
● After using the light, please power it off.
● When removing the battery, hold down
the Battery Unlock Button and push out
the battery in the opposite direction of pushing in.
Using the Video Light
1. On the Camera
● Install the L-type Bracket onto the 1/4″ Bracket
Mounting Hole and tighten the upper locking
ring of the L-type Bracket.
● Screw the lower locking ring of the L-type
Bracket to the highest point and insert the
Camera Hotshoe Connection horizontally into the
hotshoe of a camera or a camcorder. Tighten the
lower locking ring.
2. By the Handle
● Install the L-type Bracket onto the 1/4″ Bracket
Mounting Hole and tighten the upper locking ring
of the L-type Bracket.
3. On the Light Stand
● Install the light stand onto the 1/4″ Bracket
Mounting Hole
Note: If your camcorder has no hotshoe connection, it is advised to purchase a
camcorder connecting bracket in the market and install the video light through
its 1/4″ Bracket Mounting Hole.
Battery Indicator
Button
● Using DC power jack: Please choose the DC 9.0V 1.5A adapter whose DC head's
inside diameter is 1.3mm.
3. Connecting DC Power Adapter
● Turn the Power Switch off.
● Insert the DC head of the adapter into the DC power jack, and power the light on.
● Please power it off and disconnect the DC power source after using.