User's Manual
18
功能介绍
Squelch Step (SQ)
1. SQ is only valid for analog channels.
2. After SQ is set to 0, the speaker will automatically turn on and be in
the monitoring state.
3. The higher the SQ step, the better the noise oor suppression eect.
4. SQ can be congured through programming software only.
Radio Name Conguration
and Modication
1. Enter the basic setting interface of programming software to
congure or modify the Radio name.
2. Radio name can support: Letters, numbers, Chinese, special
characters, etc
.
Radio ID
1. The Radio ID is related to the private call contact, and the ID range
is 1-16776415.
2. When using a private call contact to call the other party, enter the
Radio ID of the other party and then call.
Reading/Writing Password Setting
1. To prevent information leakage, you can set the reading and writing
password through CPS.
2. Each time you read or write, you must enter the correct 8-digit
password before operating.
3. To cancel the password, clear the password and conrm.
4. To change the password, input the old password rst, and then
enter the new password to rewrite.
5. When you forget the password, you can resume the factory settings
Features