User's Manual

功能介绍

Do not turn on/o󰀨 the radio repeatedly during use, and adjust the

volume to a level suitable for your hearing.

Before using the radio for communication, please set the transmitter

and receiver to the same frequency point.

For the analog channel that requires intercom, please set the

transmitter and receiver to the same sub-audio frequency.

Menu Selection

1. The [Menu] key were set to (i) Switch channel, (ii) Set high/low

power, and (iii) Turn on/o󰀨 scanning.

2. If the radio is not operated for 3 seconds or [PTT] key is pressed, it

will exit the menu mode.

Channel Selection

In the standby state, press the [Menu] key once to enter the channel

selection menu, and then press the [+] or [-] key to select the channel.

The current channel number will be voice prompted every time you

select. If the radio is not operated for 3 seconds or [PTT] key is

pressed, it will exit the menu mode.

Channel Scanning

Press the [Menu] key twice to enter the channel scanning menu, press

the [+] or [-] key to start/stop channel scanning, and the speaker will

give a voice prompt "Scan on" or "Scan o󰀨".During scanning, the radio

scans the channels in the list and the current main channel. When

any channel in the scan list is transmitting a signal, it will stay on that

channel after scanning the signal. If press the [+] key again will skip

the current channel and continue scanning. When scanning stop, if the

radio is not operated for 3 seconds or [PTT] key is pressed, it will exit

the menu mode.

Features

功能介绍

Features