User Guide
Step1: Connect cables as the diagram.
Step2: Check Power LED is solid, LAN LED is blinking.
Step3: Add another device like this.
Step4: Check Power LED is green/solid, LAN LED is green/
blinking.
Step5: MoCA LED will be green/blinking if trafc is passing.
3. Connect cables and power on
Coax outlet
TV
Coax cable
Power adaper
PC
MoCATV
LANR ESET
PWR
LANMPS
MoCA
PWR
goCoax
6. Enable encryption(Optional)
Step1: Only power on the rst device.
Step2: Log into the device's web.
Step3: Go to the page 'Security settings', enable D-Ext band
security setting and select a proper password. Save conguration
and reboot the device.
Step4: After the device boot up, about 10 seconds, the MoCA LED
will be blue/solid.
Step5: Power on the second device.
Step6: After the second device boot up, press the MPS button of the
two devices.
Step7: Wait for the MoCA LED to be green/blue. The MoCA link is
established and encrypted.
Step8: Repeat Step 5 and 6 to add a new device into the encrypted
network. You can do the MPS pairing between the new device and
any device that is already in the encrypted network.
Step9: Sit down and enjoy your ultra-fast home network.
4. Log into the managment web
Step1: Power on the device.
Step2: Congure your PC's IP address to 192.168.254.x, for
example, 192.168.254.10. Connect the device to the PC via ethernet
cable.
Step3: Log into the device's web by http://192.168.254.254,
username: admin, password: gocoax
Step4: With the managment web, you check the current
congurations and monitor the device status.
5. Return to factory default settings(Optional)
Step1: Power on the device. Wait for about 10 seconds until the
booting up is nished.
Step2: Press the reset button more than 10s and release it.
Step3: After the device boot up, it will return to factory default
settings.
Step4: If you can visit the device's web, also you can do the factory
resetting by the menu 'Restore'.
Step5: After you click the 'Restore' button, the system will resotre
to factory default settings and reboot automatically.
7. Trouble shooting
Issue: The MoCA link is down or unstable.
Action: Use a short coaxial cable to connect the two MoCA 2.5
adapters, and check the link stability. If it is OK, means the devices
are good. Otherwise, maybe the devices have some hardware issues.
Please contact with us.
Issue: The MoCA link rate is too slow.
Action: Please login into the device's web, check the 'MoCA Link
Rates' page, nd out the current link rate. Normally, the rate should
be about 3500Mbps. If the rate is far lower than this, please check
the coaxial cable, is it a 75 Ohm cable? Also please check the splliter,
make sure it is MoCA compatible.
Issue: The device can't work with 3rd party device.
Action: We know there are two many old devices, MoCA 1.0/1.1/2.0/
bounded 2.0 and so on. Most of them have passed the maintenance
period. MoCA 2.5 is quite new and changed a lot. Maybe there will
be some compliance issues. We will try our best to be compatible
with these old devices. If you meet such issues, please contact with
us. We will help you to x such issues.