User manual
9. MOUNTING THE DEVICE IN A CAR
1. Mounting is composed of two parts
• solder (part mounted on the windscreen with a suction cup)
• strap (connector between the navigation device and handle)
2. Degrease the windscreen and holder suction cup
3. PAttach the handle to the inside of the front windscreen
4. Plug the strap into the device and connect it with suction
cup holder
NOTE!
The device should be mounted in a place, which does not restrict
driver’s line of sight and it cannot hinder the use of a car.or
hinder the operation of vehicle airbags.
Place the Goclever in a place that provides the best GPS signal
reception.
7. BATTERY CHARGING
Before you start to use your navigation system, you have to
recharge its battery. At the rst time, fully charge the battery
to ensure its maximal capacity and lifetime. We recommend
that the rst charging lasts for at least 5 hours. Subsequent
chargings may be shorter.
We recommend you to connect the GOCLEVER NAVIO 540
to car’s power supply (12V cigarette lighter) whenever you use
it to ensure an adequate level of battery charge.
GOCLEVER NAVIO 540 navigation system can also be charged
by means of computer USB port, but we do not recommend it,
since it lengthens the charging time.
However, if you want to charge the device from your computer,
connect the USB cable to the mini-USB port on the side of
the device. Connect the other end of the cable to a computer
USB port.
8. INSTALLATION OF A MICRO SD
MEMORY CARD
When the card is installed it should not be removed from the
device during the operation. If you need to remove the card,
turn o the device, press the card and remove it from the slot.
In order to install it once again: insert the card and press it
until it clicks. Then, the card is seated properly.
THE DEVICE SUPPORTS microSD CARDS up to 8 GB.
53