Operation Manual

8
Instalation
The following guides you step by step through the initial set up of the navigation system.
Firstly, remove the foil for protecting the device during transportation from the display.
How to access to the navigation system
Press Sleep/Wake up button on the unit for about two seconds to wake up the unit (Note:
Sometimes the unit will not be woken up by reason of low battery, please charge the battery.
When in charging the indicator is red). The brand logo will appear and your device will
display the application screen after a few seconds.
Attention: According to the charging status of the accumulator installed. It is necessary for
the device to be charged before the initial setting up can run through.
Charging Battery of the Navigation system
In causing of charging, the Battery Charge Indicator is red. You have different possibilities to
charge the battery of your navigation system:
 With the help of the network adapter.
 By means of the car adapter.
 The battery charge indicator lights red until the navigation system is charged. Don not
interrupt the charging process before the battery is fully charged. It will take a few
hours for the navigation system is fully charged. When the battery is fully charged the
battery indicator will turn to green.
Note: You can use the navigation system during the charging process, but the power supply
must not be interrupted during initial set-up.
Leave the mains adapter connected to the navigation system for around 24 hours, so that the
backup battery can be fully charged.
You can leave the main adapter connected, and this is very handy for continuous operation.
However, the mains adapter also requires power even when it is not charging up the battery
of the navigation system.