Operation Manual

Notes:

The memory card must always be inserted into the device during the use of the navigation

system. A Soft Reset will have to be carried out to restart the navigation system, if the

memory card is removed during its use, even for a short time.

Set the date and time by means of the Settings button and the date/time control button, if this

has not yet taken place. Set the applicable time zone, if available.

Staring Navigation

 Press the Sleep/Wake up button for about two seconds to wake up your navigation

system.

 The navigation software will start automatically or after clicking on the navigation

control button, according to the version.

 Press the menu icon to enter the destination and the address of your navigation

destination. Then start the navigation by clicking on Navigate. YOU will receive the

rout information on the screen, augmented by language statements, after a short

time, if the satellite reception is adequate.

Please take information about the further operation of the Navigation software from the

comprehensive User Handbook on the Navigation CD. In addition, brief help is available to

you on your navigation system. You will reach it by means of the Options/Destination Entry

icon and by selecting the help function.

Note: The GPS-receiver will require some minutes for initialization when deployed for the first

time. Even when GPS signal reception is indicated the navigation could be imprecise. In all

future instances it will take about 30-150 seconds until a correct GPS-signal is available,

sufficient “sight” of the satellite is a prerequisite.

Software Installation On Your PC

In order to be able to deploy self-defined cards on your navigation system you must install

the corresponding navigation software on your PC.

 Before installing the navigation software ensure that ActiveSync is installed and your

navigation system is connected with your PC via the ActiveSync-cable.

 Place the CD 1 with the navigation software in your CD drive. The installation will start

automatically. Follow the program instructions.