Operation Manual

Charging the Baery
Before using your device the baery will need to be charged. To
maximize the life of the baery the rst charge must fully charge the
baery. We recommend that you charge the unit for 2 hours in order
to achieve the full charge. Subsequent charge mes may be shorter.
Plug the mains adapter into the socket on the rear of the unit USB
port and switch it on.
The red charging indicator on the front of the unit will light. When
the unit is fully charged the red indicator is exnguished.
We recommend that when you use navigaon in your car, that you
always use the 12V cigaree adapter in order to maintain the baery
level.
Installing the micro SD Memory Card(Oponal)
Once the card is installed it does not need to be removed. If you need
to remove the card, switch the unit o rst, push the card in and it
will eject from the slot.
When re-installing it can only be ed one way - contacts towards
you and the cut-o corner at the top as shown. Slide the card in and
push fully home so that it clicks in place.
It can support up to 8GB micro SD card.
Mounng the Unit in your Car
WARNING!
Device must be mounted in a locaon that does not obscure the dri-
vers vision, impede use of the car’s controls or impede the operaon
of the car’s airbags. Screw the car mount into the back of the unit as
shown below.
4
Charging the Battery
Before using yourdevice the battery will need to be charged. To maximize the
life of the battery the rst charge must fully charge the battery. We recommend
that you charge the unit for 5 hours in order to achieve the full charge. Subsequent
charge times may be shorter. Plug the mains adapter into the socket on the
rear of the unit USB port.
Plug the adapter into the mains supply and switch it on.
The red charging indicator on the front of the unit will light. When the unit is fully
charged the red indicator is extinguished.
We recommend that when you use navigation in your car, that you always use the
12V cigarette adapter in order to maintain the battery level.
Installing the micro SD Memory Card(Optional)
Once the card is installed it does not need to be removed. If you need to remove
the card, switch the unit off rst, push the card in and it will eject from the slot.
When re-installing it can only be tted one way - contacts towards you and the cut-off
corner at the top as shown. Slide the card in and push fully home so that it clicks in
place.
It can support up to 8GB micro SD card.
Mounting the Unit in your Car
WARNING!
Device must be mounted in a location that does not obscure the drivers vision, impede
use of the car's controls or impede the operation of the car's airbags. Screw the car
mount into the back of the unit as shown below.
Car Adapter
When using your navigation in the car we recommend that you always use
the car adapter to power the unit, especially on long journeys. Plug the car adapter
into the socket marked USB port on the rear of the unit. Plug the other end on
the adapter into the car's 12V accessory socket. The illustration on the next
Manual-N90-英语.indd 4 2010-8-20 17:01:51