PURPOSE Repeater Installation The repeater is used to amplify the sensor signal forward to the display. A repeater is packaged with the this system. The unit is waterproof and can be mounted inside or outside. Working mode: when the repeater is power on, the red LED on the repeater will be on. if received sensor signal, the red LED will lash twice, Ale Power wire Black Power wire Red Working rnd true | | Frequency | 433.
Repeater installation position (6 rives] = The repeater is better to install on the middle of 2nd axle, Tro above the ground Secure the repeater with double sided tape and reinforce with screws in sacs of falling off. The repeater red wire connect positive pole, black wire connect negative pole. input voltage is 124. After Installation, pls check repeater could work.
important Notice MOTE: This equipment has been tested and found to comply with the Ur nits for a Class B digital device, pursuant to part 15 of the FCC Rules. These Hints are designed to provide reasonable protection against harmful interference In a residential installation. This equipment generates uses and can radiate radio frequency energy and, If not Installed and used In accordance with the Instructions, may cause harmful interference to adi communications.
