Installation & Operation Manual

TST-770 WSD Full Line Manual-RevA © 2021 Truck System Technologies and Pressure Systems International Inc. All Rights Reserved Worldwide.
[e-mail] [phone] M-F 9-8pm, Sat 9-2pm EST
Page 16
AUTOMATIC CODE LEARNING (cont.)
Sensor Code Capture Screen
If sensor code learning is successful, sensor ID code (Example: C5A17B) will appear on
Sensor Code Capture screen with options to Exit and Save.
Power Unit Sensor Code Learning Screen
Power Unit Sensor Code Learning Screen
Power Unit/Trailer Main Screen (after 1st sensor learning)
After successful code learning, touch Exit and Save to return to sensor code learning
screen. The programmed tire position will blink yellow and sensor code will show
(Example: C5A17B) in power unit on Sensor Code Learning screen.
Note: If sensor code learning is
unsuccessful, RESCAN will appear
on Sensor Code Learning screen
(after ~10 seconds).
Touch icon to attempt to
learn sensor code again. Repeat
above steps until sensor is coded.
Note: If the Cold Tire Pressure (CTP) has
not yet been set, the tire positions
will ash red and alerts will sound.
Tap the screen to silence, touch
main screen settings icon
to to
get to the main screen and follow
Cold Tire Pressure Alert settings
instructions on pages 11-12.
Repeat for remaining tire positions.
Touch
to nish and return to Main Screen. Learned code tire positions will blink
yellow and will show pressure and temperature readings.
Automatic Code Learning for Trailers
Touch
to enter into Automatic Code Learning settings.
Touch
, , , or to enter Sensor Code Learning settings for respective
trailers and repeat previous power unit steps.
Back To TABLE OF CONTENTS