Installation & Operation Manual

TST-770 WSD Full Line Manual-RevA © 2021 Truck System Technologies and Pressure Systems International Inc. All Rights Reserved Worldwide.
[e-mail] [phone] M-F 9-8pm, Sat 9-2pm EST
Page 13
MANUAL HIGH/LOW PRESSURE ALERT SETTINGS
Manual Input High/Low Pressure Alert Value Screen
Manual Input High/Low Pressure Alert Value Screen
Settings Menu Screen 1
Trailer 1 Cold Pressure Screen (Example)
Power Unit or Trailer Selection Screen
Touch to enter the Manual Input High/Low Pressure Alert
Value screen.
NOTE: LOW SETTING MUST BE ADJUSTED PRIOR TO HIGH SETTING.
To change Pressure Alert Value, touch the box that corresponds to the axle you would
like to change (1, 2, 3 or Spare).
Note: High Pressure Alert defaults are set at 25% above Cold Tire Pressure setting and
Low Pressure Alert will be set at 10% below Cold Tire Pressure setting.
To manually adjust High and Low Pressure Alert values, touch to enter into
Pressure Alert Settings. Touch
, , , , or to enter respective
Cold Pressure screen. Example: Touch
.
This will bring up the Keyboard Input Screen. Enter your preferred Low Pressure
Alert Value. Touch
to exit Keyboard Input Screen and repeat steps for remaining
Pressure Alert Value for this axle and then repeat for the remaining axles and spares.
Touch
again to exit Manual Input High/Low Pressure Alert Value screen. To
save your input, touch Exit and Save. To cancel, touch Exit without Saving. Selection
returns you to the Power Unit/Trailer Main Screen.
Keyboard Input Screen
NEW VALUE
Back To TABLE OF CONTENTS