Owners manual

Step-2 Attach the front center and rear brackets to the underside of the body using (2) M8 x 25mm
hex bolts, (2) 5/16” lock washers and (2) 5/16” flat washers for each bracket, (Photo 4 & 5).Leave the
bolts loose for final adjustment.
Photo 4
Passenger
Side Front
Photo 5
Passenger
Side Rear
Step-3 Locate the rectangular hole in the side of the frame that aligns with the center bracket, (Photo 6).
Note: The center bracket was removed for photo purposes.
Step-4 Position one of the nut plates behind the frame with the flat side of the nut plate covering the
rectangular hole.
Step-5 Hold the nut plate in position, and attach the passenger side auxiliary bracket to the side of the
frame using the nut plate, (1) 3/8” x 1 ¼” hex bolt, (1) 3/8” lock washer and (1) 3/8” flat washer. Attach the
opposite end of the auxiliary bracket to the center bracket tab using (1) 3/8” x 1” carriage bolt, (1) 3/8” flat
washer, (1) 3/8” lock washer and (1) 3/8” hex nut, (Photo 7 & 8). Leave the nut and bolts loose for final
adjustment.
Photo 6
Passenger
Side Center
Photo 7
Passenger
Side Center
Photo 8
Page 3