Owners manual

PHOTO 8
12. Remember to check and repair the hardware periodically.
9. If the vehicle has M8 threaded inserts in the rocker panel at the center and rear of the cab, remove the tape covering the
obround hole in the rocker panel, and install (1) 3/8” T-Plate in the oblong hole in the rocker panel and install (1) vinyl gasket
over the threads to prevent the T-Plate from falling into the body, (Photo 8). Rotate the T-Plate so the nuts welded to the T-Plate
clear the M8 threaded inserts in the rocker panel then attach one of the (center/rear) brackets to the rocker panel using the T-
Plate (1) 3/8” flat washer, (1) 3/8” lock washer, (1) 3/8” hex nut, and (2) M8 hex bolts, (2) 5/16” lock washers and (2) 5/16” flat
washers, (Photo 9). Leave the nut and bolts loose for final adjustment.
Center & Rear Bracket
10. Attach the driver side step to each bracket using (2) 3/8” x 1 ¼” hex bolts, (4) 3/8” flat washers, (2) 3/8” lock washers and (2)
3/8” hex nuts, (Photo 10 & 11).
11. Align the side step with the vehicle and tighten all bracket and side step nuts and bolts. Repeat the installation steps to
install the passenger side brackets and running board.
PHOTO 9
PHOTO 10
PHOTO 11
DESIGN QUALITY FOD17.003.E REVISION DATE: 7-14-2016 PAGE 3/3