Installation Guide

5
REV.02
STEP # 2
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
• Assemble the mounting base with the
front and rear tubes as shown. Use the
spacer specified with the front and rear
tube.
• Attach each tube to the mounting base
using (2)


⁄
” flat washers, (2)


⁄
” lock
washers and (2)


⁄
” x 1


⁄
” hex bolts,
per side.
• Do not install items 11 and 12, cover
plates, if a bed cover is going to be used.
• Do not fully tighten bolts, leave loose for
final adjustments.