Owners manual

4.- Remove (2) Torx screws securing the tail light assembly to the vehicle. Do not tighten. PHOTO # 1
5.- Pull rearward and unsnap the taillight assembly from the vehicle. Do not tighten. PHOTO # 2
6.- Assemble (1) 3/8” x 1 ¼” hex bolt and 3/8” lock washer onto the driver side rear bed rail bracket. Do
not tighten. PHOTO # 3
7.-Locate the hole in the bottom of the stake pocket opening. Do not tighten. PHOTO # 4
8.-Position the driver side bed rail bracket in the stake pocket opening, so the threaded end of the 3/8”
bolt protrudes through the hole in the bottom of the stake pocket. Do not tighten. PHOTO # 5
9.- Position one of the supplied 3/8” square nut plates with the flat surface up. Do not tighten.
PHOTO # 6
DESING QUALITY FODI.003.E PAGE. 2/4
FOTO 5
FOTO 5FOTO 5
FOTO 5
FOTO 6
FOTO 6FOTO 6
FOTO 6
FOTO 3
FOTO 3FOTO 3
FOTO 3
FOTO 4
FOTO 4FOTO 4
FOTO 4
FOTO 2
FOTO 2FOTO 2
FOTO 2
FOTO 1
FOTO 1FOTO 1
FOTO 1