Owners manual

Cleaning and care instructions:
Revised 01/07/2013
Quality:
Protect the finish with a non-abrasive automotive wax, (e.g. Pure Carnauba) on a regular basis. The use of any soap, polish, or wax that contains an
abrasive is detrimental to the finish, as the compounds scratch the finish and cause corrosion.
Design:
INSTALLATION INSTRUCTIONS
2. To install front, middle and rear mounting brackets locate in the
rocker panel the holes covered in tape and remove the tape. Place one
vinyl gasket to the bolt of the "T" plate then insert into the exposed hole.
SEE PICTURE 1.
NOTE 1: It is important to place vinyl gaskets to the bolts to prevent the
"T" plate from falling into the rocker panel.
3. Place the front and middle bracket and attach to the bolt of the plate
that it placed in the panel of the vehicle with: 3/8" flat and lock washers,
3/8" hex nut.
And
to the nuts of the T plate with: 3/8 x 1" hex head bolt, 3/8" flat and
lock washer. SEE ILLUSTRATION 3. Leave loose.
PICTURE 1
"T" plate's bolt with vinyl
gasket.
Driver's side shown.
Repeats for the central &
rear part.
REAR
Remove the tape to
expose existing hole.
FRONT
6. If you acquired a Oval side bar widesider 4", place on brackets and
attach with: 5/16" square head bolt, 5/16" Flat and lock washer.
SEE
ILLUSTRATION 5. Repeat for the opposite side. Leave loose.
7. Align Running board widesider 5" & 6" or Oval side bar widesider 4"
and then tighten all bolts.
8. Periodically check your product because it may need a re-tighten
of
bolts.
9. Fill the warranty card and place it inside your vehicle's glove box.
4. Place the rear bracket and attach of the same form that front and middle
bracket. SEE ILLUSTRATION 3. Leave loose.
Repeat in opposite side.
5. If you acquired a Running board widesider 5" & 6", insert 5/16" square
head bolt on rail, place on brackets and attach with: 5/16" Flat and lock
washer,
5/16" hex hut. SEE ILLUSTRATION 4. Repeat for the opposite
side. Leave loose.
ILLUSTRATION 3
Use ratchet & 9/16" hex socket.
3
RUNNING BOARD WIDESIDER 5" & 6" INSTALLATION
Use ratchet & 1/2" hex socket.
4 5 6
ILLUSTRATION 4
ILLUSTRATION 5
8 9 10
7
9
8
1A
2
11
3
5
4
OVAL SIDE BAR WIDESIDER 4" INSTALLATION
Use ratchet & 17mm double hex socket ( 12 point ) or
15mm Wrench.
2 de 2 FODI7.003.I