Owners manual

R&D QA FOD17.003.E PAGE: 2/3
1. Before beginning the installation read all
instructions carefully and verify that all hardware
is accounted for. if there are any listed parts
missing, please notify your distributor immediately.
2. See pictures 1, 2 Y 3
1, 2 Y 31, 2 Y 3
1, 2 Y 3 and locate the holes
where the brackets are going to be installed.
Pict. 2
Pict. 3
3. For the Front bracket install two M8x25 hex head galvanized bolts, two flat washers and two lock
washers. See Picture 5
Picture 5Picture 5
Picture 5 and repeat it in the opposite side of the vehicle. Leave loose.
4. To install middle and rear brackets
middle and rear bracketsmiddle and rear brackets
middle and rear brackets use two
M8x30 hex head galvanized bolts, two flat
washers and two lock washer for each bracket.
See Picture 4
Picture 4Picture 4
Picture 4 and repeat it in the opposite side.
Leave loose.
Pict. 4
Pict. 1
Pict. 5