Owners manual

8
REV.01
STEP # 12
INSTALLATION INSTRUCTIONS
STEP # 13
© 2016 Go Rhino Products. All rights reserved
• From under the bumper, position the driver side auxiliary bracket lower leg, over the hitch cross bar.
• Attach the bracket to the hitch cross bar using the factory M10 bolt. Leave loose for final assembly.
• Attach the opposite end of the auxiliary bracket to the bumper bracket using two


⁄
” x 1


⁄
” hex
bolts, two


⁄
” flat washers, two


⁄
” lock washers and two


⁄
” hex nuts.
• Repeat steps 12 and 13 to install the passenger side auxiliary bracket.