Owners manual

REV. DATE: 3/17/2016 Page 6 of 7
Step-6 Align the holes and attach each factory bumper support bar to each of the bumper shell support
brackets using (1) ½” x 1 ½” hex bolt, (2) ½” flat washers, (1) ½” lock washer and (1) ½” hex nut, (Photo
15).
Step-7 Align the bumper shell with the vehicle and tighten all factory and supplied nuts and bolts, (Photo
16).
If installing a winch, install the roller fairlead to the bumper shell at this time. Refer to the winch
manufacturer’s instructions for installation. If installing an optional light bar, install the light bar to the
bumper replacement at this time. Refer to the light bar instructions for installation.
Step-9 Install the winch cover and driver and passenger side front vent covers to the bumper shell using
the supplied ¼” x ¾” button head bolts, (Photo 17 & 18). Note: Do not over tighten bolts, reference
tightening torque (71 In. lbs.).
Step-10 Install the flush mount light pods to the bumper shell using (4) ¼” x ¾” button head bolts and (4)
¼” nylon lock nuts, (Photo 18).
Step-11 If desired, trim the bottom of the driver and passenger side fender liner to match the
replacement bumper. Remember to check and retighten the factory and supplied nuts and bolts
periodically.
#17
#18
#15
Driver
Side
#16